Rover 200 & 400 Owners Club

So I want this

in targa red , both sides for front bumper

https://rimmerbros.com/Item--i-DPR10075CNE,

https://rimmerbros.com/Item--i-DPR10074CNE aswell which is NLA for both

anyone able to offer help

there is claret red but I imagine this is darker? and oddly this lists only one part number but says 2 required

Just get some that are in good condition - not warped or cracked, then key + plastic primer + bodyshop primer + colour matched acrylic spray.

I use the Hycote system for plastics - adhesion promoter (extremely thin) then 1 hour later plastic primer, then a high-build bodyshop primer. Leave it all to dry for 24 hours+, flatten and key at 800 grit, and spray with top coat and lacquer.

I've used pro aerosols in Milton Keynes - just send them a colour sample by post and they'll custom-fill aerosols for you - 2 large aerosols for under £30 (I choose acrylic with UV protection added). Halfords standard lacquer over the top.

Alternatively - buy some car wrapping vinyl in a long enough strip (difficult to find for the rear bumper strip) and stick that on and fold over onto the back. You won't get targa red, but you'll be able to find a colour that is very red - and sometimes you can find it in gloss, satin and matte finishes.

Someone in the club just used insulating tape - correct width and any length you need - run it down the strip and fold over onto the reverse, then refit.

Found 2 x genuine front inserts, and the rear insert.

Have 5m of 18mm vinyl strip for sides

very close match

I have a rear one in stock, DQR10050CNE, that you can probably cut to length and fit.
Total posted 80€ (60€+20€ handling and shipping)

thanks but got one for 16 euros posted, brand new