[ROVER Cabby]

i'm not seeing the shim layer of the gasket there or is it an early pic

Just the angle of the photo.

[ROVER Cabby]

Hit a snag with this while trying to finish it of in the rain yet again, can never get a break, we
have now fitted the new rad and boxed off the coolant system, old rad was falling to bits but
it has a bad oil leak, The 'Steve' neglected to add seam sealer to the cam rail, this is what
happens when you give a gorilla a hammer and put him in a glass room.

So at some point next week the cams are out to fit it all properly, will update with photos then,
I had a faff on Monday evening and stripped down the rocker of coil packs and accessories.

1234dist was omnipresent and assisted via phone as I am a muppet.

[RoverRevival]

The question is only difficult if you don't know the answer

[961tat]

Use a 'anaerobic' sealant on cam ladder , this means it only cures when it is starved of air so any sealant you get in the oilways will not go off .

[ROVER Cabby]

I have this, came highly recommended.






Link: https://www.amazon.co.uk/Normfest-2896- ... B00PUI7BW2

[961tat]

I use elring Curil K2 , as long as it anaerobic and the surfaces at burr free and clean ( brake cleaner )no issues I've seen mastic in there before now all that work to save penny's

And don't put loads on just a smear in the right places look in the Haynes manual it tells you were to put it

[ROVER Cabby]

Mmmmmmmm, brake cleaner.

I have an unhealthy relationship with the stuff.